Front panel:
1. SPEED. CW speed pot for the WINKEY keyer. May be deactivated by software.
2. ON. Lights when the RigExpert TI-5 device is plugged in and the drivers are installed.
3. CW. Shows transmissions in CW mode.
4. PTT. Indicates when the transceiver transmits.
5. CAT. Monitors CAT data exchange between transceiver and computer.
6. FSK. Lights when RigExpert TI-5 is sending FSK data.
7. IN1. Input level, channel 1 (main receiver audio).
8. IN2. Input level, channel 2 (sub-receiver audio).
9. OUT. Output level (audio to the transceiver).
10. MIC. Microphone signal level.
Rear panel:
11. MIC. Microphone input connector (3.5 mm).
12. FOOTSW. Foot switch RCA connector.
13. TRANSCEIVER. 25-pin transceiver connector.
14. PTT/RXD. Additional PTT or CAT output (see appendix A), RCA connector.
15. PADDLE. CW paddle input (3.5 mm).
16. USB. Connect to the computer USB port.
1. SPEED. CW speed pot for the WINKEY keyer. May be deactivated by software.
2. ON. Lights when the RigExpert TI-5 device is plugged in and the drivers are installed.
3. CW. Shows transmissions in CW mode.
4. PTT. Indicates when the transceiver transmits.
5. CAT. Monitors CAT data exchange between transceiver and computer.
6. FSK. Lights when RigExpert TI-5 is sending FSK data.
7. IN1. Input level, channel 1 (main receiver audio).
8. IN2. Input level, channel 2 (sub-receiver audio).
9. OUT. Output level (audio to the transceiver).
10. MIC. Microphone signal level.
Rear panel:
11. MIC. Microphone input connector (3.5 mm).
12. FOOTSW. Foot switch RCA connector.
13. TRANSCEIVER. 25-pin transceiver connector.
14. PTT/RXD. Additional PTT or CAT output (see appendix A), RCA connector.
15. PADDLE. CW paddle input (3.5 mm).
16. USB. Connect to the computer USB port.